Monday, November 19, 2012

Winter Flip Flop Socks


In the summer, I purchased some wonderful flip flops.  They are Montrail, and mold perfectly to my feet.  They are the first flip flops (I used to get lots of cheap ones) that do not fall off my feet, or cause pain at the "thong", or wear out to fast.
As a result, and because my sore feet find them soothing, I have been wearing them as slippers around the house since the weather turned cold.
To solve a problem, I re-wrote my "best sock pattern ever" to include a mitten style toe finish.  So here is the new pattern from start to finish.  It requires an experienced sock knitter (experience with glove knitting also helps).  You will need to make a definite left and right sock.  Happy winter sandal feet!


 This pattern fits adult women, size 7-9.  Knit the foot an inch longer or shorter to adjust, and add 4 or 8  stitches in the round for men.
Yarn: 100 grams of SOCK YARN.
Needles: 4 dpn 2.25mm, plus extra yarn and darning needle to place stitches on a holder.
PATTERN:
Cast on 60 stitches and join in the round. Knit for 1.5 inches in K2, P2 ribbing. Change to K3, P1 ribbing, and continue to work in the round until total length is about 7 inches.
Heel: Put half the stitches (30 ) on one needle by knitting next 15 sts, and transfer previous 15 onto the front of this needle. Rearrange the other 30 sts onto two needles with 15 each. These 2 needles will be ignored for a while.
Working on the 30 st needles, Purl (wrong side) across. Right side: [Slip one, K 1] repeat across row. Work these two rows until repeated 15 times. (the heel should be almost square and be about 2.5 inches).
With right side facing you will now do the magic that is a heel turn! K17, K2tog, K1, turn to wrong side facing. Slip one, P5, P2tog, P1, turn. Slip one, Knit to the stitch before the gap (the space between the slipped stitch and the old heel stitches). Knit 2 tog (thus closing the gap and picking up the last slipped stitch and the next old heel stitch), K1, turn. Slip one, Purl to st before gap and P2tog over gap, P1, turn. Repeat these two rows, until all the old heel stitches are involved and worked.
Right side again: Knit across heel, pick up 15 sts up the side of the heel (put these on needle 1).
Work next 30 sts on needle 2, AND work them in the K3, P1 ribbing, as they are already still looking at you. Pick up 15 sts on the other side of the heel and knit half of the bottom of the heel sts. (needle 3). Check and make Needle 1 and Needle 3 have the same number of sts on each, adjust if needed.
Round ONE: Knit down Needle 1 to 3 sts before end, K2tog, K1, Needle 2: work in K3, P1 pattern as established, Needle 3: K1, K2tog, knit to end of needle. Round TWO: Knit needle 1, Pattern needle 2, Knit needle 3. Repeat these two rounds, until back to 60 sts (15, 30, 15). Then continue in stocking stitch for the under foot and ribbing stitch for the top of foot, until about 6 inches from the picked up stitches of the heel (or until sock is about 1.5 inches short of your foot length). 
***here is where the pattern changes from the basic sock pattern***

Left Foot:  With the top of the sock facing you (the 30 stitch needle to be worked next).... Knit across 10 stitches.  Using a darning needle and contrasting yarn, pick the next 40 stitches off the needles and leave them on the contrasting yarn (tie loosely to assure that they do not fall off.)
Going back to needle one, pick last stitch onto a new needle, and then cast on 3 new stitches.  Knit one stitch from needle 3.  (there are now 5 stitches on needle two).  Knit the last 9 stitches on the new needle 3.  You have 23 stitches for the big toe!  Knit round this toe for 10 rows.  Now decrease one stitch at the first stitch of needle one and the last stitch of needle three (this is the outside edge of the sock).  Do this decrease every other row two more times. Work one more row even, then decrease 5 evenly around the row.  12 sts remain.  Rearrange onto 2 needles, each with 6 sts, so that the toe is flat to the sock.  Use Kitchener stitch to close the top of the toe.
With the top of the sock facing you....Carefully pick up the 40 stitches from the yarn holder:  Put the first 5 on needle 1, next 15 on needles 2, next 15 on needle 3, last 5 on needle 4. Join yarn and pick up 3 sts at the base of the big toe (still using needle 4). Knit 5 sts from needle one (still using needle 4).  You now have a circle of 15 (needle 2), 15 (needle 3), 13 (new needle 1, that you have just worked).
Work in the round, knitting all, AT THE SAME TIME decrease at the outside edge (end on needle 2 and start of needle 3) every other row until 21 stitches remain.  Decrease 5 evenly across the last row, then divide onto two needles with 8 on each. Use Kitchener stitch to close the top of sock.

Right foot:
With top of sock facing you, Knit across 20 stitches. Using darning needle and contrasting yarn, place previous 40 stitches on yarn stitch holder.
Knit across next 10 stitches.  Knit next 9 stitches (needle 2). Use new needle to knit next stitch, cast on 3 sts, knit one more stitch from needle 1 (now 5 sts on needle 3).  You have 23 stitches for the big toe.  Work in knit stitch round the toe for  10 rows.  Now decrease one stitch at the end of needle one and start of needle two every other row 3 times. Work one row even, then decrease 5 evenly around the row.  Kitchener stitch the 12 rows closed.
With the BOTTOM of the sock facing you, put the held stitches on needles like this.... Slip the first 5 sts (nearest the base of the toe already knit) on needle. Slip next 15 on new needle (this one is now needle 3).  Slip next 15 on new needle (this one is needle 1).  Slip next 5 on fourth needle.  Join yarn here, and pick up 3 stitches across the base of toe with this same needle.  Knit across the next 5 stitches with the same needle (now needle 2).  You should have 15, 13, 15 on three needles.  Work around these needles, decreasing at the outside edge at the end of needle 3 and the start of needle 1, every other row until 21 sts remain.  Decrease 5 evenly across the last row, then divide onto two needles with 8 on each.  Use Kitchener stitch to close the top of sock.

Find your favourite sandals and enjoy!

18 comments:

bluelacedredhead said...

Apparently I'm not the only person in S. Ontario who wears socks with Sandals? Yes! Thanks for the sock pattern, and the suggestion on good flip flops.

Unknown said...

I'm trying this one. I put it on my 'bookmarks'.

Anonymous said...

LOVE THESE! (I am confused and and at the heel turn part...)
When you say " Repeat these two rows..." WHAT do you consider the last two rows?

chris said...

Hi there Anon, usually repeat these two rows, refers to the last two rows before the "repeat". Turning a heel is tricky, but once you get the rhythm of it, it is easy.
Always good to turn your first heel in the company of an experienced knitter... be brave!
This sock is exactly like other heel turned socks, the only difference is in the toes.
Chris

upbeads said...

Yeah ! Just finished the third pair. Easiest sock pattern ever! Love, love, love the pattern & the resulting socks!

Patricia said...

Looking for a pattern to knit adult flip flops, hoping someone has a pattern or a site they can recommend.

Unknown said...

Hi my name is Jessie, I am from UK. Can you please post a knit along video for these winter flip flop socks. I want to knit flip flop socks for my mum but without video I am not able to get the pattern sometimes. Video will be a great help. Many Thanks

chris said...

Seriously... a video request! That's a first. No, I am not that much into video recordings of myself. Best advise, knit this along with a more experienced knitter. Just like regular socks, or mittens with thumbs. Not exactly a beginner pattern, but not too difficult if you have made socks before. Best luck, Chris

Aralai said...

When you're decreasing the big toe section and the rest of the toes, are you using k2tog or ssk? Or one for the right foot and one for the left? I know one leans to the left and one to the right, so I wanted to be sure I use the correct decrease stitch if it matters.

chris said...

Aralai, you can use whichever decrease you like! I tend to use the same direction decrease, and I know that may not be as pretty as the slanted left then right, but the toe shape will still work either way. So, yes, make it prettier than mine! :)
Chris

Anonymous said...

Sock yarn? It looks thicker than sock yarn. Weight #3?

Unknown said...

I liked your request for a tutorial. I tend to get confused sometimes and find a tutorial helps and I am not a beginner knitter.

chris said...

Sock yarn , designed to knit on 2.25-2.75mm needles (US 1-2) is the yarn to use here. I don't know the weight numbers, we don't often use that around here.

I have never tried to do a video tutorial. As I suggested above, you are best to find a knitter to walk you through it, or you can watch specific stitch videos... there are lots out there....

Unknown said...

Chris, thank you for this pattern. I made a pair for my niece and she loves them. If I add the 4 to 8 inches to make a pair for a man, how would you suggest I do the toe--how many stitches should I allow for it instead of the 23 on the original pattern?

chris said...

For a man's version, use half of the "extra" stitches that you added for the wider foot, and add the half to the toe to make it a bit wider. That should work. Lucky guy!

Unknown said...

Chris, thanks so much for this pattern! I have used it many times, mostly for relatives who live in the south and never give up their flips 🙂 they love them!
Finally making myself a pair.

Unknown said...

Wonderful pattern, I've had difficulty making flip flop socks that are cuff down.
Thank you so much for this

OmaH said...

This is the best pattern EVER!!!!! I may never knit regular socks again as I am a flip flop gal and these will work in shoes as well. Thank you so much. So happy I stumbled upon this pattern